Memory modules OCZ Technology

DDR Booster Diagnostic Device With Powerclean Technology and Digital LED Readout OCZ DDR Booster Diagnostic Device with Patent pending PowerClean Technology? allows users to supply cleaner power to their memory modules, resulting in more stable memory. Additionally, users are able to view memory module voltage with the digital LEDs o­n the DDR Booster, allowing simple and inexpensive troubleshooting of the memory modules. Each OCZ DDR Booster allows VDIMM adjustments up to 3.9V* and is compatible with most DDR1 motherboards.

*Certain chipsets/motherboards may allow lower or higher voltage.

Notes:
- Use of the DDR Booster with certain chipsets/motherboards may limit maximum DIMM population.
- VTT mod may be needed to reach above 3.0 VDIMM
- Power supply quality may affect DDR Booster performance and stability.
- DDR Booster power adapter may not fit all Levicom Power Supply models due to Levicom's use of a non-standard ATX adapter.
- Power supplies used in conjunction with the DDR Booster must support a -5V line in order for the LED readout to function.
- The OCZ Booster requires a 20-Pin ATX connector and will not work with power supplies that have 24-Pin connectors

The following notes apply to the DFI NF4 SLI-DR, UT NF4 SLI-D, UT NF4 SLI-DR, UT NF4 Ultra-D and UT NF4-D:
- All testing was conducted using the 520w Modstream and all current Powerstream PSU models utilizing the 20+4 pin (split type 24 pin) motherboard connector. The 20 pin section was plugged into the booster and the detachable 4 pin was plugged into the motherboard power connector, giving the required 24 pin connection power supply connection as specified by DFI.
- It is possible to use only the 20 pin connection provided by the DDR Booster and to ignore the additional 4 pins on the motherboard power connector. This however is not approved by DFI and you do so at your own risk.
- Additionally, although our testing has yielded excellent results, OCZ cannot be responsible for any damage that may occur from the use or mis-use of the DDR booster on the DFI boards. Your warranty with DFI may be voided by the use of the DDR Booster.
- In addition, the booster requires a PSU that has a -5v line available at the motherboard power connector. This wire is ?white? according to the ATX specification. If you do not have the -5v line, the booster display will not work and the booster power circuit also may not function properly.